ANSI SCTE 126 pdf free download

ANSI SCTE 126 pdf free download.Test Method for Distortion of 2-way Amplifiers Caused by Insufficient Isolation of Built in Diplex Filter.
Please note that this procedure is a very unique procedure for testing 2-way ampliliers and distinguishes itself from other similar procedures in the following ways:
It is designed for two-way actives measurement, is single port, measures energy that leaks around the loop, injects reverse frequency into reverse input (forward output), measures 2nd harmonic distortion at the same port, and is designed to measure leakage due to insufficient isolation of built-in diplex filter.
The procedure requires measurements at multiple frequencies because this is a very frequency sensitive measurement.
For similar procedures, please reference the following:
• ANSI/SCTE 115 2011: Test Method for Reverse Path (Upstream) Intermodulation Using Two Carriers
• ANSIISCTE 145 2015: Test Method for Second Harmonic Distortion of Passives Using a Single Carrier
• ANSI/SCTE 109 2016: Test Method for Common Path Distortion
Each of these procedures targets a different measurement for a unique purpose. They are independent, are specifically applicable to the device being measured, use the test equipment commonly available at the manufacturing sites used to make the device being tested, and directly measure the impairment that must be controlled. The key differences are whether they are designed for actives or passives and whether they are single port or two port measurements. Other differences are the types of distortion products being measured and the filters required to do so.
1.3. Benefits
This test procedure provides a common method that can be used by both manufacturers and end users to test whether a 2-way amplifier meets second order distortion specifications when an upstream signal is input to the amplifier. Without such a common test procedure the testing used to prove amplifier distortion performance can vary and lead to uncertainty as to whether the amplifier distortion specifications are being met.
1.4. Intended Audience
The intended audience for this test procedure are manufacturers, evaluation laboratories, and end user technicians and engineers with the proper equipment to perform this testing.
1.5. Areas for Further Investigation or to be Added in Future Versions
At this time there are no areas for further investigation for this test procedure.
2. Normative References
The following documents contain provisions, which, through reference in this text, constitute provisions of this document. At the time of Subcommittee approval, the editions indicated were valid. All documents are subject to revision; and while parties to any agreement based on this document are encouraged to investigate the possibility of applying the most recent editions of the documents listed below, they are reminded that newer editions of those documents might not be compatible with the referenced version.
2.1. SCTE References
• ANSI/SCTE 81 2012: Surge Withstand Test Procedure
• ANSI/SCTE 96 2013: Cable Telecommunications Testing Guidelines
2.2. Standards from Other Organizations
• No normative references are applicable.
2.3. Published Materials
• No normative references are applicable.
3. Informative References
The following documents might provide valuable information to the reader but are not required when complying with this document.
3.1. SCTE References
• ANSI/SCTE 115 2011: Test Method for Reverse Path (Upstream) Intermodulation Using Two Carriers
• ANSI/SCTE 145 2015: Test Method for Second Harmonic Distortion of Passives Using a Single Carrier
• ANSIISCTE 109 2016: Test Method for Common Path Distortion
3.2. Standards from Other Organizations
• No informative references are applicable.
3.3. Published Materials
• No informative references are applicable.ANSI SCTE 126 pdf download.